Send Message

How to choose an hydraulic rock hammer?

October 29, 2021

Latest company news about How to choose an hydraulic rock hammer?

As one of the most common parts of excavators, hydraulic rock hammer are now widely used in mines, railways, highways, municipalities and other workplaces. So how to choose a good breaker, the following are some tips organized by the editor.

1. The weight and bucket capacity of the excavator

First of all, we have to consider the weight of the excavator, because too heavy a hydraulic rock hammer will cause the excavator to tip over. If it is too small, it will not achieve the economic efficiency of the excavator, and it will accelerate the damage of the breaker.

Only when the two weights match, can the excavator and hydraulic rock hammer be fully utilized.

 

hydraulic rock hammer

 

2. The working flow and pressure of the hydraulic rock hammer

The working flow of hydraulic breakers of different sizes is different. The flow of small hydraulic rock hammer can be as small as 15L per minute, while the flow of large breakers can reach more than 450L per minute.

Therefore, when selecting a breaker, the flow requirement of the breaker must be consistent with the output flow of the spare valve of the excavator.

The size of the flow determines the working frequency of the hydraulic rock hammer, that is, the number of impacts per minute, and the flow is directly proportional to the number of impacts.

Therefore, when the output flow of the spare valve of the excavator is greater than the demand flow of the hydraulic rock hammer, the hydraulic system will generate too much heat, which will cause the system temperature to be too high and reduce the service life of the components.

 

hydraulic rock hammer

 

3. The mechanism of the hydraulic rock hammer is mounted on board

There are currently three common appearance designs for hydraulic rock hammer, which are triangular, right-angled and silent.

Triangular and right-angle types usually use two thick steel splints to protect both sides of the hammer core. This structural design does not protect the front and back of the hydraulic breaker. Their disadvantage is that they are noisier than the silent breaker of the same ton. The steel plates on both sides are easy to loosen or break, and the protection of the hammer body is not good.

 

The structure of the silent breaker is that the shell completely encloses the hammer body, and the shell is equipped with damping material, which creates a buffer between the hammer body and the shell and also reduces the vibration of the carrier. Its advantage is that the hammer can be opposed to the hammer during work. The body provides better protection, low noise, reduces vibration to the carrier, and at the same time solves the problem of loose housing, which is also the mainstream and development trend of the global market.

Get in touch with us
Contact Person : Mr. Tang
Tel : 86-18922117251
Characters Remaining(20/3000)