This year, let’s talk about the key points of excavator rock arm. If you are also a master of rock arms of excavators, you must listen carefully. If you want to talk about driving requirements, many people also have years of driving experience. It shouldn’t be necessary to say more about this. They are all old drivers, but there are several points worthy of our attention during the driving process. Remember, the custom-made excavator rock arm must not be operated like this.
Most of the time, the excavator rock arm is broken or digging. How should we operate it when we often face this kind of working conditions? It is precisely because we have been dealing with stones for a long time and everyone knows the physics of friction and heat generation, so we have to take a break after working for a period of time. Don't not rest just to work in a hurry, because the temperature reaches a certain temperature and the steel is hard. The degree will decrease. If you continue to work, the front device may bend, etc., and we don’t want to use cold water to irrigate in order to continue working. This is very bad. I believe everyone has experienced this. I have been working for a long time. After that, the front part of the device will be hot and red, and at this time it is even more difficult to water it. Although this can quickly cool down, it will greatly reduce the life of the machine.
Normally it is to wait for him to cool naturally, so as not to damage the machine. If you want to increase the life of his mission, natural cooling is a good way, and we should also pay attention to the cylinder pressure of the rock arm of the excavator and the sharpness of the front device. Degree, these are the key factors of work efficiency, as long as these are done well, the excavator rock arm can better serve us and get better feedback in the work.