There are many types of excavators, but you may be the most aware of the bucket type, and you may not have a deep understanding of other types of accessories. Today we will talk about digger grapple .

The digger grapple is mainly used to load, unload and transport excavator parts such as stones, wood, scrap iron and steel. The correct installation of equipment can ensure the normal use in the later period. The following is an introduction to the installation and use of the digger grapple. Hope The following content can be helpful to everyone.

1.Correctly select the digger grapple and iron grab that matches your excavator model and job needs to avoid improper selection that affects the power, increases the load of the excavator, and shortens the service life of the excavator.

2.Before installing the digger grapple, please confirm whether the various scales match the scale of your excavator. After confirmation, you can connect the digger grapple with the excavator to avoid installation failure due to size errors.

3.When installing the hydraulic pipeline of the digger grapple, start to fix the front end of the forearm of the pipe route used by the digger grapple. After leaving a margin for movement, connect and fix the forearm and boom of the excavator. Then select a reasonable position of the double valve to connect with the excavator, and fasten the digger grapple pipeline to it, and the oil in and out is led out from the spare valve of the excavator to fasten it.

After this series of operations, you can try to turn it on. When using it, you must pay attention to maintenance and maintenance, and avoid illegal operations.